1 1

Pellon

Interfacing - Fusible Lightweight (906F)

Interfacing - Fusible Lightweight (906F)

$5.00 CAD
$5.00 CAD
Sale Sold out
Shipping calculated at checkout.

Pellon® 906F Fusible Sheerweight is an ultra lightweight, non-woven, fusible interfacing for sheer to lightweight fabrics. It is great for wovens and knits such as crepe de chine, voile, and handkerchief linen.

  • Non-Woven
  • White
  • 100% Polyester
  • 20″ by-the-yard width
  • Sheerweight fusible interfacing
  • Sewing machine safe
  • Machine wash warm. Tumble dry low or dry clean.
Notes & Tips:
-There is no preshrinking required. ALWAYS PRE-TEST on a scrap of fabric; fusing is
not recommended for triacetate, lace, seersucker or rainwear.
-Use steam iron with metal sole plate. Hand-held steamers will not permanently bond
interfacing to fabric.
-Use your damp press cloth as a temperature and timing guide. After 10–15 seconds,
press cloth should be dry. If not, raise iron temperature or hold iron in place a few
seconds longer.

General Directions:
1. Trim & steam baste:
Pin pattern piece to interfacing following grainline arrows; cut. Trim seam allowances
to 1⁄4” (6mm). Next, place fusible (this is the rough shiny side) on the wrong side of
fabric. Pin, then steam baste along edges with tip of iron. Remove pins.
2. Fuse:
Cover with a DAMP cloth. Set iron on wool/steam setting: Press firmly for full 10–12
seconds. Repeat, lifting and slightly overlapping until all interfacing is fused. Steam
press on right side. Let fabric cool, then check bond.

Care Instructions: Hand wash finished project, or machine wash on gentle cycle, cold
water with gentle soap (keeping in mind any specific instructions for the fabric used. No
bleach. Lay flat, drip dry, or dry clean.
View full details